Ever bump into problems just trying to get your models to mesh? Here are five quick tips that I use almost every time I need to troubleshoot a difficult model. In this video, you'll see an example based on a real customer model which showcases a few of the most common pitfalls to watch out for. These same tricks apply to assemblies as well, but you may need to go part-by-part to test some of these ideas out. These are the tips used in this presentation: Tip 1: Blended Mesher Tip 2: Geometry Analysis Tip 3: Partition Model Tip 4: Geometry Modification Tip 5: Wireframe to Examine Topology