GoEngineer Blog

#1 Technical Resource Worldwide – Right at Your Fingertips.
Search or Browse SOLIDWORKS & 3D Printing Product Developments, Announcements, How-To Guides, and Tutorials

Showing Articles written by Taran Packer

SOLIDWORKS Simulation Premium has 11 material model types that will influence the results of a Linear or Nonlinear Analysis. These models types are located in the Properties tab in the material properties (See Figure 1) and will be defined individually in this article. These definitions are not comprehensive. They are only intended to give SOLIDWORKS Simulation Premium users a general understanding of how each material model works in the solver.

 

SOLIDWORKS Simulation plot graphical changes (such as isolate, hide/show, exploded views) are not updated automatically. The plot that was visible before the change remains visible after the change unless additional steps described below are followed. This is due to the fact that the results data loads based on the original view state, the plot must be refreshed. There are three separate methods of regenerating a SOLIDWORKS Simulation plot after a graphical change has been made.