GoEngineer Blog

To properly activate the SolidNetWork License Manager, there a few steps involved that should be completed before updating the clients. Install/Upgrade the SolidNetWork License Manager using the Installation Manager. Open the SolidNetWork License Manager. You should see five tabs, one being the Server Administration tab.

Inside every seat of SOLIDWORKS, a copy of DriveWorksXpress is included at no additional cost. However, the activation needs to happen before the software can be used. Note: View our DriveWorks page to compare DriveWorks packages. If you look under the “Evaluate” tab in SOLIDWORKS you will see the icon for DriveWorksXpress Wizard.

Often a SOLIDWORKS user will have the wrong file location paths for an installation of SOLIDWORKS, which can cause the program to either fail or produce ineffective behavior. This article provides a clearly defined outline of the referenced paths that SOLIDWORKS requires to perform correctly.

This tutorial demonstrates how to create a product-specific admin image in SOLIDWORKS that needs to be added to a SOLIDWORKS installation. This can also be used to install a product for a user that only needs the specific product, and not the entire installation.

SOLIDWORKS Flow Simulation can adapt the computational mesh to the solution during the calculation. The software splits the mesh cells into the high-gradient flow regions and merges the cells in the low-gradient flow regions. This ensures better accuracy during the calculation. The mesh starts from an initial state and is modified during the calculation based on user-defined settings.

This tutorial explains how to edit flattened harness routes in SOLIDWORKS Electrical 3D. Flattened representations of a SOLIDWORKS harness can be difficult to read in its default state. With the 'Edit Flattened Route' command, a high-quality representation of the flattened route can be created with ease.

This article describes one method to insert a multi-pin connector in SOLIDWORKS Electrical Schematics. The first step is to create the connector in either the component tree or by placing a connector pin symbol on a scheme page in your project. This set of images shows how to insert a component through the Component tree.

When creating a new PDF from a SOLIDWORKS Composer document, a few steps need to be taken first. This article explains how to complete this initial setup and publish the document.

SOLIDWORKS Flow Simulation allows for the creation of custom fan conditions to emulate physical fans. This can be done in three different ways. The first method entails creating a fan curve. The other two methods allow for a more accurate representation of the fan by including additional attributes defining the physical characteristics of the fan: axial fan and radial fan.