GoEngineer Blog

#1 Technical Resource Worldwide – Right at Your Fingertips.
Search or Browse SOLIDWORKS & 3D Printing Product Developments, Announcements, How-To Guides, and Tutorials

Showing Articles by Category: SOLIDWORKS Flow Simulation

Once an initial Flow project has been completed in SOLIDWORKS Flow Simulation, there is an additional tool we can use to optimize our goals. This is a Parametric Study called Design of Experiments and Optimization. The Design of Experiments and Optimization study allows us to optimize our design with multiple input variables.

 

Have you ever cooked a hot dog and then burned your mouth because you couldn't wait? I have, and I then wondered, "what is the best way to orient a hot dog so it cools down the fastest?" National Hot Dog Day is July 20th, so we might as well find the solution. The best method depends on your situation. This post shows how SOLIDWORKS Flow Simulation is a viable solution to manage heat transfer between a solid body and a fluid. 

During takeoff and landing, fixed-wing aircraft often deploy flaps to increase lift. The lift required is a function of multiple variables, and the maximum possible lift is not necessary for most takeoffs and landings. However, understanding the relationship between flap deflection and lift is essential for aircraft design to reduce the speed and runway length needed at takeoff and landing.

We can sometimes have too many goals in our SOLIDWORKS Flow Simulation projects to sweep through a model to see what values we can find from whatever direction they may come from. In the example below, we have a racer wing with multiple goals on the different parts.

In this guide, we review how SOLIDWORKS Flow Simulation can simulate the transient pressure pulse on a design where a fluid is allowed to enter and exit at different intervals. By setting up this study, we’ll review the time-dependent functionality where we can control the different areas of the fluid travel through a system caused by a pressure drop.

 

The mixing of fluids is a phenomenon that needs to be accurately modeled in order to understand the behavior of the different fluids involved, as well as understanding the rate that the mixing happens. SOLIDWORKS Flow Simulation allows the use of non-newtonian fluids, gases, real gases, and liquids. For fluid mixing, all of the fluids being mixed must be in the same state. 

 

Nikola Tesla invented many things. One of his little-known inventions is the Tesla valve, a one-way valve without any moving parts. SOLIDWORKS Flow Simulation is the perfect software to demonstrate how a Tesla Valve works because it can easily calculate the laminar and turbulent flows and show the results of the flow field through the entire device without anything obstructing the flow through the device. 

 

 

By default, when a SOLIDWORKS Flow Simulation user starts a new project under the Input Data folder, there are only a few categories: Computational Domain, Fluid Subdomains, Boundary Conditions, Goals, and Mesh. While these options are the most commonly used in Flow Simulation, they do not represent all the tools available in the software.
There are four different pressure definitions used in SOLIDWORKS Flow Simulation: Static Pressure, Total Pressure, Dynamic Pressure, and Environment Pressure. Static Pressure is the pressure at a single point in the moving flow field as the gas or liquid flow moves through a system. Static Pressure can be measured as the flow passes over a device that introduces no velocity change to the flow or a device moving with the flow field.